Hi all, new here. I have owned this little Toyota Liteace for a couple of months, cousins with US van you could say. In this van (2WD) is a coil-sprung rear axle with multi links. Since day 1, I have been trying to track down the source of a clunk, which is in the back half of the van when going over bumps.

So far have addressed the following issues:
- new rear shocks which were sloppy / rattly
- adjusted rear hatch latch to prevent door from shaking
- new tires as a matter of course
- chased down and fixed various wire harness mounting points to prevent the harnesses knocking inside the body
- have put my hands on and wiggled about everything I can find in the rear half of the car
- front sway bar bushings (unrelated)
- replaced all three motor mounts (was getting rubbing on crossbar)

Next on my list to check:
- gas tank mounting straps
- give the spare tire carrier a closer look
- ?

Running out of ideas here. Its entirely possible my efforts at finding a loose joint by hand are just not going to work, maybe need something like a crow bar?

Name: IMG_E0645.jpg Views: 342 Size: 95.4 KB