Activity Stream

If you get frustrated because there is no room for your wrenches, and that everything is metric, and that you dropped one of the washers for the...

There has been no noticeable temperature difference. It's still producing a slight electrical smell 1 year later. I'm assuming it's due to the...

This thread should be of some help. https://www.toyotavantech.com/forum/showthread.php?756-Changing-the-fuel-filter

Jan-Willem is correct. This is a canister type filter and is replaced as a whole unit. If the canister itself is leaking then a new filter is all you...

did you notice any difference in the running temp with this alternator installed? cant imagine it would make that much of a difference, but im...

That's because he read the thread on that. :) https://www.toyotavantech.com/forum/showthread.php?7474-cup-holder-clip-latch-repair

Still have an AC compressor?

Njordi is now idling like new. So the simple fix for idle issues is clearly to rebuild the throttle body, rebuild the IAC valve, replace the EGR...

Just got my first test drive done and can confirm that these couplers are running balanced and smooth. Here is a video of my first start up, you...

The R-134a charge on a Previa with rear AC is very conveniently 1020g which works out to be exactly 3 cans of refrigerant. Charged it up this...

My centering seems to have worked well turns both directions equally, but I got my steering wheel alignment a bit off, will need to adjust that...

https://www.youtube.com/watch?v=oy-V_9h1KUA Feels amazing to have Njordi back to life! I did a 1 minute run to check the start and get the head...

Did you ever find out the issue? I’ve got a 95 Townace doing the same thing now. Exhaust smoking when revving engine, nothing when idling. Just...

The initial post above was for my '91, whose transmission was out of the vehicle in my garage. I just did the same job on my '93, whose...

I only bolted the new caliper and bracket in, either way there wasn't enough room to get the outside pad on and pivot the caliper in place. Over...

Part number wise, there is a difference for 86 only, otherwise maybe there is something in the bottom of the slide pin bore keeping it from sliding...

Yes, The caliper I got was also for an 87, but as i read from another thread in this forum 85 through 89 calipers will fit. Maybe theres something...

Are you saying you bolted the caliper on before putting the pads on?

Tech support told me that its normal single DIN dimensions, those measurements were for the face plate. So I ordered this What I really wanted...

Got the pump on this morning and the tie rod ends installed... I guess that measurement from the FSM to center the rack was not correct. Haha, WAY...

Looks like we are working on mirrored vans! Here is one more shot I took of mine to help the thread. My boot was also fully destroyed. I found...

The neutral safety switch on my van has an intermittent issue so I installed ab switch needs to be pressed while starting the car.

I can confirm this job is pretty much a PITA. First step is to remove the air cowl and air box from the front end so you can access the power...

Yeah I replaced my master cylinder (not the booster), because my pedal was sinking slowly,with or without engine running. Plus its nearly 40 years...