Hey guys, sorry if there's a thread on this already, but I couldn't find what I was looking for. I just just recently changed the fuel filter on my '86 2wd, and when I was done the van wouldn't start. I checked spark and it was good, so I tried jumping the fuel pump test connector and nothing happened. The pump runs for a second when the key is turned on, but the test connector wouldn't make it run. Checked and the EFI fuse is blown. Replaced it and tried cranking again - blown again! Anybody have any insight on where I might have caused a short? Any wires around the fuel filter I should check? Just asking here first before I go ripping the dash apart to test the harness. Interior parts are NLA

Thanks in advance!! PS, anybody else bend the heck out of that fuel filter bracket?