Activity Stream

OK, now the engine comes out. to be continued

If you decide to leave the harness attached to the body as opposed to the engine, here are the differences... Leave the oxygen sensor part of the...

Disconnect both oxygen sensors connectors and get the harness off the body. Good luck getting that middle exhaust pipe section off. WD40, heat,...

Electrical connectors from driver's access hole.... Upper right... cold start injector (black, 2 prong) Upper left with pink paint......

The air intake removal section actually has a nice diagram. Woo hoo. Basically you're disconnecting everything from the large intake duct.... the...

Whoops :doh::doh:, well I was asking since I couldn't locate a part number that matches the ones in the bulletin physically on the bevel gear assy....

Between this thread and the one I linked earlier, this is all the info I have. That picture you posted is the bevel gear mounting bracket. And that...

Whew, double checked my VIN numbers and thankfully my van skirted these just by a model year! That's a relief. :lol: But, onto another question...

Mine's pretty clean too :)

Back to the FSM steps. "water by-pass hose from floor pipe" "brake booster hose from floor pipe" No diagram here, unfortunately. This...

This post should have been earlier in the thread. This is how I jacked and supported the car while feeling safe working underneath. It is completely...

There's a nice sketch of the ECU connectors, but where TF are they? I crawled around all under the van looking for them and eventually did a web...

OK, time to get down to the removal details. I am referencing my 1991 FSM. I'm assuming all future years are similar. Some of the steps are very...

Equipment I used for this. *A space which allows the vehicle to be raised 18" from its normal resting height. The lower edge of the door sill...

That's what some people with 3rd gen manual 4runners have done. There is plenty of flex in there, though probably best for old bushings to keep it to...

Small lifts with leaf springs are easily achieved with extended shackles and relatively inexpensive too

It sure feels good to have that lump in the garage now. Here are answers to questions posed earlier in the thread. Remove the lower nut from...

I meant to say that I installed LED lights that cost $100 and they didn't work at all. I was very disappointed and gave them away. With new bright...